Re: VCR dead - fuse blown?
- From: "Mark D. Zacharias" <spammenot@xxxxxx>
- Date: Mon, 4 Apr 2005 05:28:29 -0500
Helpful info:
Brand, model, age of the unit.
A blown fuse should be readily visible to the naked eye.
Unplug it before changing, and only use the same value fuse.
Mark Z.
<wizzzer@xxxxxxxxxxx> wrote in message
news:1112600093.332402.41030@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> There was a partial black out tonight. The lights got very dim for
> about an hour. The VCR was recording when it happened and it stayed on
> at the reduced energy level. Then when the electricity came back to
> full power, the VCR died. It has no power at all. Do you think it blew
> a fuse?
>
.
Relevant Pages
- Re: Panasonic TV - TC-25V30R - fuse blows repeatedly
... supply would have to be first serviced, and then the horizontal output ... main fuse holder. ... check for any bad power transistor in the supply section (since power ... I think of first confirming if the SMPS is good, ...
(sci.electronics.repair) - Re: whats wrong with this circuit?
... Short the output to ground with the fuse blown and the ... This is not what I would call good regulation. ... 70dB of ripple rejection. ... linear DC power supply. ...
(sci.electronics.repair) - Re: Electric dryer - thermal fuse question
... Our Sears electric dryer went completely dead about 2 seconds after ... power even to the 10 watt light inside the drum. ... on that thermal fuse that flips between .5 and .6 ohms. ...
(sci.electronics.repair) - Re: help needed: watt/sec ?!?
... Lets say it's a 1A fuse. ... Then the power would be 110W. ... Since this is a strobe light, the peak power is only there for a while ... You also need to think about the battery. ...
(sci.physics) - Re: looking for balanced power conditioner.
... all power connectors are ... We tend to take EMC a little more seriously, and power supply safety very ... But with a single sided supply, that fault will blow the fuse within 0.4 ... If the gear has not been modified to fuse ...
(rec.audio.pro) |
|
