Re: Compact Fluorescent Failures



Matthew Smith wrote:

Greetings

Over the last couple of months, I have had a spate of failures of compact fluorescent lamps (electronic ballasts). (All of the lamps in our house, barring the ones that aren't kept on for any time, are CFLs.)

Whilst a couple have been generic Far-Eastern ones, I've had a couple of failures of Philips units as well. (Back in England, one of the first Philips electronic CFLs was still running well after seven years.)


<snip>
In another, the electrolytic capacitor
had failed (end blown out); I replaced it and it runs fine, although I have yet to replace the thermal fuse.

I'm now painstakingly tracing the circuits of two of the Philips units so that I can mark up some voltage readings against "healthy" units. I was rather surprised to find that even the latest units are constructed with through-hole, discrete components. (What, no integrated switcher?)

I have gutted a couple Philips lamps with an LBA202(?) SMT IC.
Little else of interesting components in such a lamp...
All the rest (far Eastern, as well as European made Osram and Sylvania)
using a couple transistors in a power oscillator circuit.
Of the several (must be more than twenty!) I have gutted the electrolytic most often has failed. I changed it in one of the lamps, which held more than six months afterwards. The lamps which show darkening of the FL tubes are nothing to keep, they probably are at the end of life.
I have seen exploded transistors, but only in a couple of the lamps.
They are small video output transistors in a 'long TO92' case in the far-East imports.
I collect the ferrite toroids and the hi-voltage caps after measuring them. Some are nice replacements in tube gear..
The caps are marked with values and are nearly always within tolerances.


Some questions:

1) Does anyone have any figures for commonest causes of failure? (In other words, where do I look first?) 

Electrolytic. It dries out from high ripple current/high temp in the lamp.

2) Are the thermal fuses essential? Not all units seem to have them - at least that I can identify.

Some have only a glass-cased fuse in one of the socket wires, some have fusible resistors. I have seldom seen temp fuses.


Stein

.

Relevant Pages

  • Re: panasonic pt-50lc13 problem
    ... Hmmm, my reading of the settlement (I have one of these sets, though ... There is an alternative "multiple failures" ... It does appear to be for lamps, ...
    (alt.tv.tech.hdtv)
  • Re: Tech - Williams System 9 Pop Bumper wiring
    ... System 9 should not have transistors under the playfield. ... bumper coils should not fire the lamps. ... well as why the pop lamps have higher gauge wire ...
    (rec.games.pinball)
  • Re: how to get more amps to my lamps?
    ... and have replaced the random resistors that were in ... of my transistors simply didn't work...I bought a brand new pack from ... Rad Shack and replaced the transistors for the lamps that weren't ... > Put the lamps in the collector lead rather than the emitter lead of the ...
    (sci.electronics.basics)
  • Re: Whitewater question
    ... Most common failure part on the small driver board for the #194 lamps ... However, if you have multiple lamps out, then I would ... examine the schematic diagram for the small driver board (back section ... transistors, resisters and chips. ...
    (rec.games.pinball)
  • Re: LCD monitors Inverter bad ?
    ... I checked the transistors using my DMM but they seem all right to me. ... My inverter has two transistors for ... does the other side's lamps also turn off? ...
    (sci.electronics.repair)
Quantcast