IR Motion Sensor Question

From: oldcoot@xxxxxxxxx (Bill Sheppard)
Date: Sat, 23 Apr 2005 10:02:58 -0700

Hi
I'm building a security system for my apt. building, and
will be using those IR motion sensors that turn on floodlights. Is it OK
to connect an inductive load (a transformer) in parallel with the
floodlight? Thanks
Bill

Header address is a spam trap. E-mail: oldcoot88atwebtv.net Change 'at'
to @

.

Follow-Ups:
- Re: IR Motion Sensor Question
  - From: david
- Re: IR Motion Sensor Question
  - From: Bill Jeffrey

Prev by Date: Re: Sony KV-32S22 Remote Problem
Next by Date: Re: Viewsonic A90f color issue
Previous by thread: Sony KV-32S22 Remote Problem
Next by thread: Re: IR Motion Sensor Question
Index(es):
- Date
- Thread

Relevant Pages

Re: Dimmable transfomers
... a 'dimmable transformer' may be a switch-mode supply. ... > use a phase-controlled dimmer on an ordinary transformer. ... inductance in series with the low resistance of a cold lamp load. ... The inductive load will very likely result in "half waving" at some dimmer ...
(sci.electronics.design)
Re: fa: anyone about to start experimenting with pyrography - this can save you some $$
... Bill, I don't think a transformer, in itself, is an inductive load. ... I used a dimmer to control the speed of a vacuum cleaner motor acting as the ...
(rec.crafts.woodturning)
Re: Sharp Microwave powers down after 40 seconds, need assistance
... Like your idea better i.e. substitute for transformer loading--nice ... inductive load should balance well. ...
(sci.electronics.repair)
Re: Sony STR-DE635 recieiver wont power up
... The "standby transformer" is that T902 on the schematic? ... I've got 13.5V on the header that leads to the "Digital" board. ...
(sci.electronics.repair)