Re: Toshiba beta V



now this is something i am familiar with.


let me know if i can be of assitance :)


there should be a plate door on the bottom of the unit. open it up.
replace the belt. any vcr repair center will have them. just an old
regular belt. while you are at it.. if you turn the unit the right
way, open it up, remove the tape loading mechanism.. you will find a
rubber wheel . this wheel needs to be replaced as well. its probably
old, and cracked. easy to find on the net.

On Sun, 1 May 2005 21:04:23 -0500, "testortool"
<mbillings@xxxxxxxxxxx> wrote:

>Chances are a rubber belt in the machine has went bad. It was going bad when
>you used the machine months ago since the belt couldn't supply enough
>friction for tapes to rewind which is a common early sympton, but now it has
>lost even more friction. Now the VCR senses a major problem in the tape
>transport due to a malfunctioning belt and shuts down automatically. It's
>easy to replace VCR belts. There should be about 4 screws securing the top
>cover. Make sure the AC cord is unplugged, remove the cover and look for
>rubber belts. Sometimes belts are located on the bottom sides of VCRs, so
>you may need to remove a few screws to remove the bottom metal plate. Some
>belts are so small you can use O rings found at most home improvement stores
>for a few cents each. If it's larger, you can try using a rubber band. A
>rubber band fix may not last permanently, but it will get you by and you'll
>know how to replace it again if necessary. Good luck.
>
><jberry@xxxxxxxxxxxxx> wrote in message
>news:1114906976.642999.17910@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>
>>I haven't played any tapes in my Toshiba V-S443C Betahi-fi VCR (this is
>> Beta, not VHS) in several months. I just tried, and they don't play.
>> The machine tries for a second, then stops itself.
>

.



Relevant Pages

  • bandsaw problems
    ... assumed it was the belt that links the motor to the saw. ... I then opened the bottom cabinet ... tire back on the wheel and made sure the two wheels were in alignment ... the wheel and the blade obviously fell off of the bottom wheel also. ...
    (rec.woodworking)
  • Re: Mitsubishi HS-u53 VCR has jerky picture
    ... >> I took the bottom cover off of the VCR to check the belt, ... I couldn't see any slipping. ...
    (sci.electronics.repair)
  • Re: bandsaw problems
    ... assumed it was the belt that links the motor to the saw. ... I then opened the bottom cabinet ... tire back on the wheel and made sure the two wheels were in alignment ... the wheel and the blade obviously fell off of the bottom wheel also. ...
    (rec.woodworking)
  • Re: Mitsubishi HS-u53 VCR has jerky picture
    ... >>> I took the bottom cover off of the VCR to check the belt, ... >>> belt looks okay. ... I couldn't see any slipping. ...
    (sci.electronics.repair)
  • Re: Crank bolt....(stuck..)
    ... > but since the water pump has gone, presumably the belt is no longer ... > connecting top and bottom, so turning on the starter might bend even more ...
    (uk.rec.cars.maintenance)