Re: RCA CTC 203 Haeter Filaments



On Wed, 18 May 2005 16:52:55 -0400, "Michele Smith"
<michele062@xxxxxxxxxxxx> wrote:

>Thanks, I'll do that.

Please check that CTC203 location L14401's glue is cleaned off; have
to unsolder and remove coil, clean off hot glue and clean out the two
holes that coil's leads goes through. Reinstall coil & solder
normally.

Cheers,

Wizard
.



Relevant Pages

  • Re: Mylar removal
    ... I do not know what is in GooGone, ... I wanted the surfaces to be COMPLETELY clean of all oils and foreign ... The alcohol does a good job disolving all kinds of oils ... 20 year old glue much better and faster. ...
    (rec.games.pinball)
  • TX825 /826
    ... The HOT died because of glue in the base drive coil ... While in there I replaced TP15 with a beefier part. ... There is a loose short jumper wire with a ...
    (sci.electronics.repair)
  • Re: CTC 203 opinions please,( before I tear ALL my hair out)......
    ... >would not be a bad thing except for the fact that I will have lost a ... >customer. ... >I know that the coil will probably eventually fail and take out the ... If this TV with CTC203 has glue around that coil, ...
    (sci.electronics.repair)
  • Re: Do you prefinish your projects (online poll)
    ... This should make glue ... clean up a lot easier. ... With wood movement and seasonal shrinkage door panels ... Just shameful. ...
    (rec.woodworking)
  • Re: Advice needed for 1964 Williams Zig Zag
    ... a clean assembly is a happy assembly. ... On other solenoids that have moving fiber links, ... Worn holes rob these assemblies of power that you would ... visible sign of a shorting coil (Large pools of molten copper, ...
    (rec.games.pinball)