Re: Let talk: TN50X81 (chassis TAC9960), convergence stuff

From: dkuhajda@xxxxxxxx
Date: 8 Jun 2005 17:43:16 -0700

IC? Most convergence module failures I have seen were due to the
surface mount capacitors. If it has then, ESR all of them before
replacing any ics.

.

Follow-Ups:
- Re: Let talk: TN50X81 (chassis TAC9960), convergence stuff
  - From: Jason D.

References:
- Let talk: TN50X81 (chassis TAC9960), convergence stuff
  - From: Jason D.

Prev by Date: Panasonic 36sx31e degauss circuit problems
Next by Date: Sony KP57HW42
Previous by thread: Let talk: TN50X81 (chassis TAC9960), convergence stuff
Next by thread: Re: Let talk: TN50X81 (chassis TAC9960), convergence stuff
Index(es):
- Date
- Thread

Relevant Pages

ESR reading?Good/ BAD ESR value? surface mount capacitor cause ripple wavy LCD?
... I have just replaced 2 surface mount capacitors, their ESR (using Dick ... the monitor is still wavy after the repair. ... Is it possible that the ripple is caused by something other ...
(sci.electronics.repair)
Re: Good capacitors
... motherboard caps; I noticed in CompUSA the other day that they were ... here have revived dead mobos just by replacing the power supply caps. ... the ESR went up, causing the capacitors to heat up and swell, or break ... where an ESR meter comes in handy. ...
(sci.electronics.design)
Re: Mutsubishi cs-26EX1 ,sn# 003704
... Start at the PIP module, all the surface mount capacitors will be bad. ... Then ESR check all the capacitors in the set, likely you will find 2 to 3 ... David ...
(sci.electronics.repair)