Re: Sony Clie TJ27 (PDA) - vertical roll

Hey Wes,

Your advice worked Great but...

I removed each clamp and flex ribbon and reseated them back into place using
a microscope.

I turned it on and it appeared to work fine, but...

the battery does not appear to recharge or power the unit any more.

While the connection appears loose, it seems that I can measure the battery
voltage just past the connection.

Any ideas on what I may have done or what may have happened during the fall?

Thanks again,

Mark

"Wes." <spamthis@xxxxxxxxxxxxxx> wrote in message
news:1118911988.2e199cec2986ce2101078a11e3572ab5@xxxxxxxxxxx
>
> "Mark" <mmwink@xxxxxxxxxxxxx> wrote in message
> news:8c1se.102073$8S5.65944@xxxxxxxxxxxxxxxxxxxxxxxxx
> >I dropped my PDA on the ground, nothing cracked. The unit turned on, but
> >the
> > display on the screen appears to be rolling vertically and so quickly,
you
> > cannot make out anything but color.
> >
> > Any insight on what I might check before I buy something else?
> >
> > Thanks in advance,
> >
> > Mark
> >
> >
>
> You could be lucky and have the clamp on the flex ribbon to the Display
Assy
> pop open. They open up like a clam shell, this would reduce the contact
> pressure on the connector and cause all sorts of problems.
>
> Ether that or you've cracked something.
>
> Wes.
>
>


.

Relevant Pages

  • Re: Motomatic II servo driver
    ... I'm trying to set it up with limit switches as the wiring diagram shows in the manual, but it's not responding for the trigger of the switches to put the motor in revers. ... >>FAC and rac is the FORWARD and REVERS Clamps lines. ... The forward amplifier clamp and reverse amplifier clamp are directional clamps ... The input connection for the ...
    (alt.machines.cnc)
  • Re: Made a screw earth clamp for welding
    ... I suspect your connection between the contact block and the wire will deteriorate fairly quickly. ... I would suggest a crimp connector on the wire bolted to the side of the contact block. ... Perhaps I should have used longer set screws, but it would have made the clamp clumsier and 10 mm were what I had. ... My stinger has this kind of connection (minus the solder) and it hasn't broken yet. ...
    (rec.crafts.metalworking)
  • Re: Let me try this question here
    ... what did you use to clamp them together with? ... crimper, or a clamp, twist tie, electrical ... Is the connection subject to mechanical ...
    (rec.woodworking)
Quantcast