Re: X-ray danger whilst working on TV?


"PCK" <someone@xxxxxxxxxxxxx> wrote in message
news:o4udnawU4qpbrSvfRVn-jA@xxxxxxxxxx
>
> <maarten@xxxxxxxxxxxxxxxxxxx> wrote in message
> news:2ab66$42b5531c$82a12456$4569@xxxxxxxxxxxxxxxxxxx
> > James Sweet <jamessweet@xxxxxxxxxxx> wrote:
> >> Huh? Typical CRT monitor is 150W, typical LCD is 35W, even if the LCD
> >> uses a
> >> tiny bit more in standby, it still comes out far ahead in most cases.
> >
> > You are right of course, I was not thinking when I wrote this. What I
> > meant to say was, don't think it will consume no power when switched
> > off. In some cases it can draw in excess of 10 watts then, compared with
> > a typical 0.5W power draw for a CRT monitor. It will make up for this
> > when used more than a few minutes a day, but still.
> >
> > ---
> > Met vriendelijke groet,
> >
> > Maarten Bakker.
> what are you smoking dutchman seems to be stronger than pot
> 1/2 a watt CRT on stanby?
> get real the freakin pilot light on the front uses that much
>
>

I think he meant when you turn it completely off, in which case it shouldn't
use any power at all, while an LCD will normally have an external PSU which
is powered up all the time.


.

Relevant Pages

  • Re: X-ray danger whilst working on TV?
    ... Typical CRT monitor is 150W, typical LCD is 35W, even if the LCD ... > a typical 0.5W power draw for a CRT monitor. ... 1/2 a watt CRT on stanby? ...
    (sci.electronics.repair)
  • refrigerators vs CPUs, et. al. (Was)Re: September Surprises...
    ... Especially on a sailboat, power draw is a big consideration. ... What kind of refrigerator do you run, ...
    (rec.boats.cruising)
  • Re: Viewsonic P810 ribbon cable
    ... From there you should be able to work out what the signals ... why, when I get a CRT monitor, if it gets too involved, I scrap the monitor. ... the component along with some caps, all on the neck board. ... when power applied, ...
    (sci.electronics.repair)
  • Re: Air Conditioner Problem/New Baby!
    ... outlet then I'll get my KAW out and check the power before plugging in. ... I ALWAYS monitor the power draw of any HVAC unit that I install and start up ... My solution was to install a GE switchboard analog meter just under my master ...
    (rec.outdoors.rv-travel)
  • Re: OT? power reqs of DDR2 chips
    ... estimate power draw for the system and can't seem to find a reference. ... Kingston Value Ram, if that matters. ... The box _will_ run Fedora. ...
    (Fedora)