Re: Switch won't turn of Outlet



badaczewski@xxxxxxxxx writes:

> I recently replaced a switch(interupter) and a duplex
> outlet(receptacle) in my home. The switch had the ability to turn
> on/off power to the top outlet on the duplex receptacle. After
> replacing the switch and the receptacle I get no response from the
> switch. Both the top and bottom outlets on the receptacle have power,
> but I can no longer turn off the power to the top outlet of the duplex
> receptacle. I'm using Leviton Decora products and have confirmed by
> looking at the old switch and recpetacle that I have bought the proper
> replacements. I've included a link to a diagram I drew of my current
> wire setup, can anyone give me some insight into why the switch doesn't
> work?
>
> Here is the link:
> http://www.strangemedia.net/receptacle.gif
>
> P.S - Before replacing anything I wrote down the placement of all the
> wires and I don't believe the wires are connected incorrectly.

You need to break off the link connecting the Hot side of the top and bottom
recepticals.

--- sam | Sci.Electronics.Repair FAQ Mirror: http://repairfaq.ece.drexel.edu/
Repair | Main Table of Contents: http://repairfaq.ece.drexel.edu/REPAIR/
+Lasers | Sam's Laser FAQ: http://repairfaq.ece.drexel.edu/sam/lasersam.htm
| Mirror Sites: http://repairfaq.ece.drexel.edu/REPAIR/F_mirror.html

Note: These links are hopefully temporary until we can sort out the excessive
traffic on Repairfaq.org.

Important: Anything sent to the email address in the message header above is
ignored unless my full name is included in the subject line. Or, you can
contact me via the Feedback Form in the FAQs.
.



Relevant Pages

  • Re: Hardware Problem?
    ... Just read your post about replacing the mobo--congratulations! ... |>switch was continuously depressed. ... Try unplugging the reset switch from ... |>pins which the power switch plugs into. ...
    (microsoft.public.windowsxp.basics)
  • Re: OT - Light Switch Replacement
    ... Sorry receptacle, as opposed to switch. ... It flashed and beeped and was quite sure there was plenty of power at ... I walked it over to the busted switch and nothing. ... I will keep the Live Wire ...
    (rec.outdoors.rv-travel)
  • Re: OT - Light Switch Replacement
    ... what a bulb screws into and a receptacle is what a plug plugs into and you ... Sorry receptacle, as opposed to switch. ... It flashed and beeped and was quite sure there was plenty of power at ... I walked it over to the busted switch and nothing. ...
    (rec.outdoors.rv-travel)
  • Re: PC doesnt start
    ... measure some DC voltages from power supply. ... that must measure 4.87 volts DC when computer is not powered on. ... power switch is pressed AND drop to well below 0.8 volts when power ... knowing what is bad before replacing anything. ...
    (microsoft.public.windowsxp.hardware)
  • Re: computer wont start - no sounds
    ... Better is to first see a problem before removing or replacing ... Power switch does not connect to the power supply. ... Voltage change says nothing useful. ...
    (alt.comp.hardware.pc-homebuilt)