Re: Re HDTV Teac cm-687 is this what I should try?
- From: maarten@xxxxxxxxxxxxxxxxxxx
- Date: Wed, 20 Jul 2005 17:14:48 +0200
alitonto <alitonto@xxxxxxxxxxx> wrote:
> I now must say that the AGC pin from the tuner is connected directly to
> the pin of the I/C; no resistor is connected in series between the 2
> pins.
> However there is a couple of resistors off this line therefore in
> parrallel. Is this still okai to do the test?
There is a risk of blowing up the IC. Disconnect the tuner pin and use a
variable power supply directly to the AGC pin of the tuner. Or use a 9V
battery with a 10k variable resistor.
---
Met vriendelijke groet,
Maarten Bakker.
.
- References:
- Re HDTV Teac cm-687 is this what I should try?
- From: alitonto
- Re: Re HDTV Teac cm-687 is this what I should try?
- From: maarten
- Re: Re HDTV Teac cm-687 is this what I should try?
- From: alitonto
- Re HDTV Teac cm-687 is this what I should try?
- Prev by Date: Re: Focus after replacing Flyback Trans. JVC
- Next by Date: How to rust proof underwater alligator clips?...tia sal
- Previous by thread: Re: Re HDTV Teac cm-687 is this what I should try?
- Next by thread: JVC TV part values needed
- Index(es):
Relevant Pages
|
