Re: Sony CPD G410R Monitors

CRaSH wrote:
> John wrote:
>> I have a number of Sony CPD G410R monitors that appear to have to
>> high A1 voltages. That is brightness to high and flyback lines just
>> apparent in the dark areas of the picture.
>> I wish I knew how to adjust this or some service information so I
>> could check voltages etc.
>> If you could help lots of thanks in advance ....John.
>
> Have you tried the 'color restoration' feature in the menu? I had
> the same problem on my G420, and didn't use it because I asummed it
> was just color balance, but it also restored the correct brightness
> setting. Someone suggested it (also says it in the manual - doh),
> and it worked wonders!!

BTW - it won't let you do it until the monitor is warmed up about 20
minutes...
Don


.

Relevant Pages

  • Re: Sony CPD G410R Monitors
    ... > I have a number of Sony CPD G410R monitors that appear to have to ... > could check voltages etc. ... Have you tried the 'color restoration' feature in the menu? ... but it also restored the correct brightness setting. ...
    (sci.electronics.repair)
  • Re: Magnavox RH8524 Blue shifted left
    ... >> I've used the scope on digital circuits however the voltages inside a tv ... You may not need the scope on ... like to push the brightness and picture all the way up. ...
    (sci.electronics.repair)
  • Re: Viewsonic P225F horizontal failure
    ... LCD monitors do not wear faster with higher contrast settings. ... The brightness control in some models does not change the brightness ...
    (sci.electronics.repair)
  • Re: Is my monitor really broken?
    ... circuit which monitors various voltages. ... Some also have a shutdown that detects lack of deflection, most monitors have separate HV and horizontal circuits so if the horizontal deflection transistor is shorted, cold solder joints, etc the monitor will have similar symptoms. ...
    (sci.electronics.repair)
  • Re: Solution to brightness problem?
    ... I've fixed a number of monitors by tweaking the power output of the transformer, therefore increasing the brightness of the screen. ... If you leave it as it is, it may reach a particular level and not get any worse, or it may continue getting darker until it's unusable and you have to hook in a external monitor... ... I don't recommend doing this yourself - I'm a qualified electronics engineer, so I'm certified to blow myself up. ...
    (uk.comp.sys.mac)