Re: Convergence problem

Bias resistors off the STK,s return .
kip
<stokesb@xxxxxxx> wrote in message
news:1128072977.926000.169050@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
> Hitachi 50EX10B. I have the convergence looking almost perfect, except
> I can't straighten out the bow (down) on the bottom of the screen
> viewing cross hatch pattern. I had no control of blue, so I replaced
> all the convergence amp IC's (figured good idea since the set is 11
> years old). This fixed the blue problem. I can get about the center 2/3
> of the bottom line to straighten, but both corners turn down, and no
> conv. adjustment on the board removes this. I don't see where I can
> adjust anything else to fix this. Is there another component at fault?
> Thanks to all.
>


.

Relevant Pages

  • Convergence problem
    ... I have the convergence looking almost perfect, ... I can't straighten out the bow on the bottom of the screen ... This fixed the blue problem. ... adjustment on the board removes this. ...
    (sci.electronics.repair)
  • Re: Convergence problem
    ... kip wrote: ... This fixed the blue problem. ... >> of the bottom line to straighten, but both corners turn down, and no ... adjustment on the board removes this. ...
    (sci.electronics.repair)
  • Convergence solved Hitachi 50dx10b
    ... Snagged a free 2001 50" projection TeeWee Hitachi 50DX10B. ... up OK.The convergence was way off, mostly blue to the right and up. ... 'Shift' button enabled adjustment, using the Vol and Channel buttons. ...
    (sci.electronics.repair)
  • Re: Convergence solved Hitachi 50dx10b
    ... up OK.The convergence was way off, mostly blue to the right and up. ... 'Shift' button enabled adjustment, using the Vol and Channel buttons. ... I'd clean what I could with a vacuum. ...
    (sci.electronics.repair)
  • Toshiba TP 43H60 Convergence problem
    ... This one I found really strange. ... adjustment only works on the top and right side. ... convergence board It seems OK visually. ...
    (sci.electronics.repair)
Loading