Re: Carver PM-1.5 Amp Help

bytraper:
Get your DMM out and take voltage measurements in the power supply and
make some component tests, primarily the semiconductors, low ohm
resistors and electrolytics in the audio power output/driver stages.
Also, be certain that you have not forgotten to jumper the preamp
out/main in connections if there are any..... and make sure that all
the switches are in the correct position and a tape monitor or adaptor
switch is not left on.
The good news is that because a stereo amplifier has duplicate
circuitry in the Left and Right channels you can easily make circuitry
comparisons. It would be unusual that BOTH channels would have
exactly the same failures so be certain to look at the things that both
channels have in common like the power supply and the switch positions,
etc.
electricitym
..
..

.

Relevant Pages

  • Re: Odd PRI problem on 81c
    ... I once had a failure of a DMS100 card in a Bell South ... I even had a T1 test set and two site visits from Bell South ... When I STAT the channels they show IDLE. ... I think the CO switch is a Lucent -- but, so far, no hard ...
    (comp.dcom.sys.nortel)
  • Re: Odd PRI problem on 81c
    ... DSBL, but Verizon has cleared most of that circuit while testing. ... When I STAT the channels they show IDLE. ... I think the CO switch is a Lucent -- but, so far, no hard ...
    (comp.dcom.sys.nortel)
  • Re: DTV switch problems still linger
    ... Viewers complain problems picking up channels ... Many viewers have found that they can't pick up certain stations after ... the switch, even with the right TVs or converter boxes. ...
    (rec.arts.tv)
  • Re: TV ON switch wont latch
    ... I have Cable TV for the basic channels plus the first tier ... After that the ON switch wouldn't latch. ... As for mis-reconnecting the cable all the cables have keyed connectors ...
    (sci.electronics.repair)
  • Re: In Move to Digital TV, Confusion Is in the Air [Telecom]
    ... The FCC now has asked some TV stations to continue broadcasting Public Information Messages over the Analog channels for up to 2 weeks after the switch. ...
    (comp.dcom.telecom)