Re: Convergence problem

Look around the STK,s for low value about 1.2 to 2.0 ohm close tolerance
resistors.

kip
<stokesb@xxxxxxx> wrote in message
news:1128085711.128407.316290@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>
> kip wrote:
>> Bias resistors off the STK,s return .
>> kip
>> <stokesb@xxxxxxx> wrote in message
>> news:1128072977.926000.169050@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
>> > Hitachi 50EX10B. I have the convergence looking almost perfect, except
>> > I can't straighten out the bow (down) on the bottom of the screen
>> > viewing cross hatch pattern. I had no control of blue, so I replaced
>> > all the convergence amp IC's (figured good idea since the set is 11
>> > years old). This fixed the blue problem. I can get about the center 2/3
>> > of the bottom line to straighten, but both corners turn down, and no
>> > conv. adjustment on the board removes this. I don't see where I can
>> > adjust anything else to fix this. Is there another component at fault?
>> > Thanks to all.
>> >
>
> Thanks for the info Kip. I'll look over the schematic to try to find
> these and test(I'm fairly new in repair). I'll post with results. Do
> these usually short, or drift way off value?
>


.

Relevant Pages

  • Re: Convergence problem
    ... kip wrote: ... This fixed the blue problem. ... >> of the bottom line to straighten, but both corners turn down, and no ... adjustment on the board removes this. ...
    (sci.electronics.repair)
  • Re: "New" CDs: Bloomfield, Pennario, Gibson, and more!
    ... "Saint-Saens: Wedding Cake" is the third item from the bottom. ... Kip W ...
    (rec.music.classical.recordings)