Re: 12 volt VCR Samsung/Visteon

If you look closely at the last of three pix you posted, you can
see that the top left connection goes to ground via a jumper.
The two pins soldered together on the pc board, are likely
ground. Check for continuity from them to ground anywhere
on the chassis. There is a battery (always 12 volts), & ACC
which is 12 volts (when the key is on). Sky.


.

Relevant Pages

  • show connections command
    ... "show connection" on a PIX? ... Ikke ... Prev by Date: ...
    (comp.dcom.sys.cisco)
  • Re: PPTP Clients loose connection to cisco PIX 506E after a while..
    ... A customer of mine have just gotten a new Cisco Pix 506E, ... I've heard is that they loose connection after a while, ... pdm location 213.179.57.7 255.255.255.255 outside ... timeout xlate 0:05:00 ...
    (comp.dcom.sys.cisco)
  • Re: PIX 501 help please!
    ... > PIX rebooted. ... (tried straight through and X-Over cables from PIX to modem) ... Checking the LEDs on the pix to ensure connection, ... enter and it should write the configuration to memory. ...
    (comp.security.firewalls)
  • PIX Firewalls cut-through proxy
    ... Cisco PIX handles HTTP connections? ... Cisco http connection management is as follows: ... In User Service and policy is checked, the PIX Firewall shifts ...
    (Security-Basics)
  • Re: PIX 501 help please!
    ... hyper terminal console. ... >> PIX rebooted. ... Checking the LEDs on the pix to ensure connection, ... > enter and it should write the configuration to memory. ...
    (comp.security.firewalls)
Quantcast