Panasonic CT32E33G EP407 chassis

Hi All,

Still struggling with this TV. Had a shorted STRW5634, after replacing
the IC all the voltages read about 1/2 their actual value.

Eg 12 V standby reads approc 6 volts.

The 3.3 V to micro is good and hitting the power switch the TV tries
starting up but then shuts down again. I verified that the optoisolator
was good but replaced it anyway that did not help.

All electrolytics show up good on an ESR meter and the diodes around
the flyback read OK.

Has anyone run into a similar problem with panasonics?

Thanks
Jay

.

Relevant Pages

  • Re: Replacing Chopper Transistors on Switching PSU - QSC Says to Have it Factory Calibrated!
    ... 'recalibration' after replacing the switching element - or indeed any ... pots for output voltages, then yes, the rails should be checked and reset ... Also, the gate drive resistors, ... junction breakdown voltage. ...
    (sci.electronics.repair)
  • Re: Game Resets now Black Out
    ... seem to be on games that are/were left on 24/7 in the arcades or in some ... testing first before replacing the bridges. ... Tested the wall power, ... total black out I took your sugestion and started testing for voltages ...
    (rec.games.pinball)
  • Re: AC ripple
    ... dc voltages at all the test points, but also get ac ripple across ... them.....thinking about replacing all the capacitors on the board. ...
    (rec.games.pinball)