hp Color Laserjet 4550 transfer belt error

I have a hp color laserjet 4550 that displays "check transfer belt"
and refuses to print. It shows this error after warm up, but before
calibration. I tried the belt in another 4550 and it worked fine. I
confirmed that the belt is moving by noting the location of a mark on
the belt. Someone else has already looked at the printer and
supposedly replaced "everything" without fixing it. I'm the last
effort before it's scrapped. Has anyone seen this error before?
Andy Cuffe

baltimora@xxxxxxx <-- Use this address until 12/31/2005

acuffe@xxxxxxxxx <-- Use this address after 12/31/2005
.

Relevant Pages

  • Re: hp Color Laserjet 4550 transfer belt error
    ... and refuses to print. ... It shows this error after warm up, but before calibration. ... I confirmed that the belt is moving by noting the location of a mark on the belt. ...
    (sci.electronics.repair)
  • Re: hp Color Laserjet 4550 transfer belt error
    ... > I have a hp color laserjet 4550 that displays "check transfer belt" ... > and refuses to print. ... I tried the belt in another 4550 and it worked fine. ...
    (sci.electronics.repair)
  • Re: Spring PNWCO
    ... Part of why I picked the campground I did was the area gets some rain ... require a warm coat and maybe the heat turned on in the RV (the ... And I made it home, too - but the a/c belt broke just after Prosser, so ... water pump, a second belt runs the power steering and the water pump, and ...
    (rec.outdoors.rv-travel)
  • Re: Spring PNWCO
    ... Part of why I picked the campground I did was the area gets some rain ... require a warm coat and maybe the heat turned on in the RV (the ... And I made it home, too - but the a/c belt broke just after Prosser, so the ... pump, a second belt runs the power steering and the water pump, and the ...
    (rec.outdoors.rv-travel)
  • Re: Delta 46-700 runs really warm
    ... > Well, as the topic says, my Delta 46-700 seems to run really warm. ... The belt looks fine and the pulleys ... > bearings completely quit on my decrepit Craftsman lathe. ...
    (rec.crafts.woodturning)