Re: Who makes this resistor?


"VMI" <VMI@xxxxxxxxxxx> wrote in message
news:43d39b4f$0$13572$ba620e4c@xxxxxxxxxxxxxxxxx
> First to Arfa,
> I know that any resistor will do the electrical part but it have to be
> this size; the box otherwise wouldn't close!
> Dimensions MUST BE the same.
> Hence my question "Who can be the manufacturer of these resistors..."
>
> Then to Mark:
> Do you have exactly the same resistors in your drawers?
> Can you possibly tell me "Who can be the manufacturer of these
> resistors..."
> Do you have access to a service manual of Sony?
> What type of receiver is it?
>
> I hope I cleared up the particular problem of this repair and many to
> come, if I look at the number of repairs allready done.
> I do not like to be dependent of the service department of a manufacturer;
> I like to know where they get their components from.
>
> Thanks any way for passing by.
>
> Cheers,
>
> Zilog
>
> Mark D. Zacharias wrote:
>> "Arfa Daily" <arfa.daily@xxxxxxxxxxxx> wrote in message
>> news:fHzAf.42324$W4.26774@xxxxxxxxxxxxxxxxxxxxxxx
>>
>>>"VMI" <VMI@xxxxxxxxxxx> wrote in message
>>>news:43d27609$0$1180$ba620e4c@xxxxxxxxxxxxxxxxx
>>>
>>>>Hi,
>>>>I have in front of me some 5W power resistors.
>>>>Value = 2 x 0.22 Ohms.
>>>>It has 3 legs. Center leg is straight, outer legs have a bend.
>>>>Size is: Thickness = 5mm, Height = 17 mm, Width = 26mm.
>>>>Color = White.
>>>>Material = Ceramic.
>>>>Writing =
>>>>first line: 5W 0.22OhmsJX2
>>>>second line: C (symbol looks like an s in a circle) and at the end of
>>>>the body a sort of reversed e
>>>>That's it...
>>>>They are used in Dyna cord power mate amps.
>>>>Who can be the manufacturer of these resistors...
>>>>
>>>>Thanks,
>>>>
>>>>Zilog
>>>
>>>Does it matter who makes them ? They are quite common in audio amps. Seem
>>>to recall that Welwyn is one company. If you need to replace one, and
>>>haven't got access to manufacturer's original parts, it's quite in order
>>>to make one up from two 5 watt 0R22 resistors, connected in series, with
>>>a third wire from the junction point.
>>>
>>>Arfa
>>>
>>
>>
>> I had to quit pulling these fron scrap Sony receivers - my parts drawers
>> were overflowing! Sony gets about 5.00 each for them, but I only use
>> them once in a while!
>>
>> Mark Z.

I haven't measured mine - they're at work after all, but it sounds like
they're the same. Mine mostly have leads at the top and bottom though. Handy
for measurement but maybe a problem it yours are really in such tight
quarters.
Don't know who makes them.
We also have bought similar resistors from MCM and other suppliers, no leads
on top, though.

Mark Z.


.

Relevant Pages

  • Re: Help with Sony 34XBR800 7 blinks Whats most likely cause
    ... I get five blinks on the diags which I assume is just the white balance ... Also what are the reference designators for the resistors you mention I ... Mark Z. ... These things are often intermittent. ...
    (sci.electronics.repair)
  • Re: Help with Sony 34XBR800 7 blinks Whats most likely cause
    ... MArk Thanks I ordered one and hopefully that solves it ... Also what are the reference designators for the resistors you mention I ... are the output transistors and the most likely cause ...
    (sci.electronics.repair)
  • Re: parts resistors transistors
    ... > I cant seem to find these transistors and resistors ... Try Farnell: ... Mark ... Prev by Date: ...
    (sci.electronics.basics)
  • Re: Cheap ESR Meter
    ... atrocious blue-bodied 1% resistors, me included/especially. ... the Mark 2 meter's kit notes includes this little caution: ...
    (sci.electronics.repair)
  • Re: Who makes this resistor?
    ... I have in front of me some 5W power resistors. ... outer legs have a bend. ... They are used in Dyna cord power mate amps. ... I had to quit pulling these fron scrap Sony receivers - my parts drawers were overflowing! ...
    (sci.electronics.repair)