Re: Trying to fix a Marantz SR-2000 receiver

On Mon, 06 Mar 2006 13:12:54 -0500, trousky1@xxxxxxxxxxxx wrote:

Thanks Charles,
I checked the voltages(DC) on all pins on both hybrid power amps and
they are the same. I swapped the input to the hybrid power amps (left
and right channels) and I still have the same power amp getting very
hot. Not sure what to check next.


Without speakers connected,of course?
.

Relevant Pages

  • Re: Tubes Vs. Transistors Is There An Audible Difference?
    ... The major factor is the quality of the speakers chosen, ... a Dynaco tube preamp, a Soundcraftsman 2217, ... The power amps were dynaco Mk III 60w tube amps, ... amp section of the Marantz 2325 receiver, and his Bryston 3Bs. ...
    (rec.music.classical.recordings)
  • Re: Active vs Passive monitors
    ... Active speakers are typically bi-amped, ... Also, the power amps will be well matched to the speakers, ... I can well understand the lack of a fan but do they dissipate the amp heat ...
    (rec.audio.pro)
  • Re: HDMI + audio switcher
    ... the centre speakers, pre out for the other 3.1 channels) plus couple of power amps for rear & centre duty. ... I used to use it for decoding as well, but they were never going to do HDMI switching or decoding. ... Tyger Burning Bright ...
    (uk.rec.motorcycles)
  • Re: Active vs Passive monitors
    ... Active speakers are typically bi-amped, ... And bi-amping offers more ways to optimize ... Also, the power amps will be well matched to the speakers, ... distortion by a significant amount. ...
    (rec.audio.pro)
  • Re: Balanced connections on domestic equipment.
    ... speakers normally powered?, the only area where powered speakers ... This poster was talking about an AV preamp where all the power amps are ... I was looking at a Denon AV pre-amp a while back that had balanced outputs ...
    (uk.rec.audio)