Re: OT: Aircompressor Pressure Release between tank and air pump
Need to put a check valve between the pump & the tank, to take the load
off the motor at start
.
Relevant Pages
- Re: Pool timer wiring dilemma
... So the motor is switched on when both leads go hot. ... What I don't understand is how the pump switch activates the motor. ... It likely gets its power via the gfci and the switch. ... It would appear that one leg of the load, ...
(alt.home.repair) - Re: Variable load for testing phase convertor
... >increasing the load. ... >> machine I have is a power hacksaw with a 1 3/4 hp motor. ... >> Motor driving variable pitch propeller in small tank of liquid. ... >> Bolt car brake disc/drum to motor pulley. ...
(rec.crafts.metalworking) - Re: Is there any reason not to charge a compressor upto 8bar?
... If it has 8 bar in the tank as opposed to 7, ... go slightly higher IF the pump and motor combination can handle the ... The manufacturer deliberately sets the pressure switch in the ...
(rec.crafts.metalworking) - Re: Ingersoll Rand T-10 compressor - any good?
... air for a T&C air bearing, topping off tires, and that sort of thing. ... The seller claims it has a 5 HP motor that draws 15 amps at 220 single-phase ... If the tank is an ASME tank in good condx and the pump is rated for ... 11+ ACFM at 90 PSI and is in good shape, then the tank and pump are ...
(rec.crafts.metalworking) - Re: Variable load for testing phase convertor
... Maybe you could do something on these lines with a large car alternator. ... So today I was wondering how I could create a variable load in the range 0.5 to 2 hp. ... The only three phase workshop machine I have is a power hacksaw with a 1 3/4 hp motor. ... Motor driving variable pitch propeller in small tank of liquid. ...
(rec.crafts.metalworking) |
|
