Re: Hitachi AP53 Chassis, Convergence out, STK's statically check, Res / alignment question

While the chassis is out just go over it with Mag
Glass for dry joints especially in the Conv Section.

kip

"Markus" <mporter@xxxxxxxxxx> wrote in message
news:ogmg2292pol83hldmk2kdb8h1tluuehudd@xxxxxxxxxx
Kip,

Thanks for checking, looked a little out of place. I ordered the stks
and will check the power supplies that feed them. I think I worked on
this same chassis a few years back. Think it had some sort of power
problem. Seen a few with the 'frosted up lens' problem. This one
looks pretty clean especially for its age.

Take care,

Markus

On Sun, 26 Mar 2006 22:25:30 -0500, "kip" <nospam@xxxxxxxxxx> wrote:


RK15, 16 are 5.6 Ohm
RK20, 21 are 4.7 Ohm
RK25, 26 are 8.2 Ohm
RK30, 31 are 6.8 Ohm
RK35, 36 are 6.8 Ohm
RK41, 42 are 4.7 Ohm

These are correct values from the Schematic..

kip




.

Relevant Pages