Re: Microwave oven



On 17 Apr 2006 06:40:14 -0700, "Retired" <everettlarsen@xxxxxxxxxxxxx>
wrote:

The capacitor showed a short to case after running for about 2
minutes, but would again test OK after being off for a while. The wave
guide and the rest of the oven look A1. The magentron look good also.
No ;I got no heat in that 1 minute that I ran it. I had a cup of water
in it, and it stayed cold. I am beganning to think it is the magnetron
even though I can not prove it.

I used to fix them years ago. I made a resistive divider which I could
use to measure the high voltage at the cathode using a conventional
voltmeter. If the heater windings are OK and the voltage is about 2500
(IIRC) then replace the magnetron.

Cheers.

Bill.
.



Relevant Pages

  • Re: Microwave oven
    ... It sounds like the magnetron is shorting or pulling too much current when it ... high voltage diode shorted and the high voltage capacitor going bad. ... The magnetron tube was replace 3 months ago and the transformer tests ...
    (sci.electronics.repair)
  • Re: Microwave oven
    ... high voltage diode shorted and the high voltage capacitor going bad. ... The magnetron tube show no short to case. ... There's only 4 parts there - HV transformer, HV capacitor, HV diode, ...
    (sci.electronics.repair)
  • Re: Wiring for halide lamp
    ... "magnetron" transformer, but I have no idea where to find one, either. ... too high voltage, and too low current. ... Andrew Gabriel ...
    (sci.engr.lighting)

Quantcast