Re: Inverter Repair... I could use some pointers from the experts.

From: "Michael Kennedy" <Mikek400@xxxxxxxxxxxxxxxxxxx>
Date: Thu, 20 Apr 2006 03:10:49 -0400

I took the transformers off and they both ohm very similarly... I think they
are both good, but it is late and I'll give it a more careful check
tomorrow.

- Mike

"Michael Kennedy" <Mikek400@xxxxxxxxxxxxxxxxxxx> wrote in message
news:MLidnUd1gr0ci9rZRVn-pA@xxxxxxxxxxxxxx

Okay... The color charts I found versus the colors on this diode don't
make sense.. It is orange, red, black and green.. so that makes it a
1N320E ?? I can't find any diodes with that part number.

Maybe I'm just color blind.. Can someone tell me if I got the colors
right?
http://mikescomputer.homeip.net/LCD/DSC00382.JPG

Color Codes I found
http://www.oldradios.co.nz/data/index5.htm

- Mike

Follow-Ups:
- Re: Inverter Repair. Still blowing fuses..
  - From: Michael Kennedy

References:
- Inverter Repair... I could use some pointers from the experts.
  - From: Michael Kennedy
- Re: Inverter Repair... I could use some pointers from the experts.
  - From: Dave
- Re: Inverter Repair... I could use some pointers from the experts.
  - From: Michael Kennedy
- Re: Inverter Repair... I could use some pointers from the experts.
  - From: Michael Kennedy

Prev by Date: Re: Re: Heathkit crt tester
Next by Date: Re: UK part question
Previous by thread: Re: Inverter Repair... I could use some pointers from the experts.
Next by thread: Re: Inverter Repair. Still blowing fuses..
Index(es):
- Date
- Thread

Relevant Pages

Re: Converting a quad-EL84 power amp into a guitar amplifier. Advice requested.
... preamp module to plug into that power amp. ... tubes and transformers and cap cans coming up and all the ... secondary, into an 8 ohm resistor load, gave 2.442 VAC. ...
(alt.guitar.amps)
Re: 70v. output transformer?
... All the wires emerge from one side of the bell housing. ... IMGIC, they are meant to drive other transformers, the ... or perhaps you're driving electrostatic panels, ... but what if you put about a 64 ohm load on that setup? ...
(alt.guitar.amps)
Re: 70v. output transformer?
... All the wires emerge from one side of the bell housing. ... IMGIC, they are meant to drive other transformers, the ... or perhaps you're driving electrostatic panels, ... but what if you put about a 64 ohm load on that setup? ...
(alt.guitar.amps)
Re: 70v. output transformer?
... All the wires emerge from one side of the bell housing. ... IMGIC, they are meant to drive other transformers, the ... but what if you put about a 64 ohm load on that setup? ... can't you use a high ohm speaker load on the 70V winding? ...
(alt.guitar.amps)
Re: 70v. output transformer?
... All the wires emerge from one side of the bell housing. ... IMGIC, they are meant to drive other transformers, the ... or perhaps you're driving electrostatic panels, ... but what if you put about a 64 ohm load on that setup? ...
(alt.guitar.amps)