Re: Making my own coax cables
- From: Andrew Rossmann <andysnewsreply@xxxxxxxxxxxxxxxxxxx>
- Date: Sat, 29 Apr 2006 16:29:16 -0500
In article <1146343412.927600.209150@xxxxxxxxxxxxxxxxxxxxxxxxxxxx>,
toronado455@xxxxxxxxx says...
I would like to make my own custom-length coax cables. What are the
best cable cutter, stripper and crimper for the money? (I'm assuming
three seperate tools here). I don't want to spend too much money since
this is just for around the house and not pro, but I don't want cheap
junk that's a waste of money either.
For my basic home TV cable use, I just use reqular wire cutters for
the cable. For stripping and the F connectors, I have a Sargent 8600ESC
(for RG6 and 59). It strips the end, you put on a Snap-N-Seal type
connector, insert it into a holder, and screw down a little thumbscrew
to push it on.
--
If there is a no_junk in my address, please REMOVE it before replying!
All junk mail senders will be prosecuted to the fullest extent of the
law!!
http://home.att.net/~andyross
.
- References:
- Making my own coax cables
- From: toronado455
- Making my own coax cables
- Prev by Date: Re: Ferrite/Choke question
- Next by Date: Re: Cable Tv picture Improvement design
- Previous by thread: Re: Making my own coax cables
- Next by thread: Re: Making my own coax cables
- Index(es):
Relevant Pages
|
