Re: Heat source for heat shrink

In article <44595dd0$0$3705$822641b3@xxxxxxxxxxxxxxxxxxxxxxxx>,
David Nebenzahl <nobody@xxxxxxxxxxxxxxx> wrote:

heat a little bitty piece of tubing? Are there any "mini heat guns"
available to heat smaller things?

Not a butane pencil torch (sounds like a blowlamp!) but I use the side
"exhaust port" of an Oryx Portasol butane soldering iron. Usually because
I can't be bothered to change the (hot) soldering iron tip for the proper
hot air blower attachment! In either case, you get a good stream of hot
air, with no flame. Does just fine for small sleeving, might take a while
for larger stuff though!
--
--------------------------------------+------------------------------------
Mike Brown: mjb[at]pootle.demon.co.uk | http://www.pootle.demon.co.uk/
.