36" RCA T.V.

T.V. works fine, but has minor noise in pix. It takes time for it to
show
up, but gets no worse, & comes & goes. You have to look close to see
it! Looks like noise in the horizontal, throughout the whole pix, the
words
on info channels quiver, ever so slightly. No bad connections in the
horizontal
drive/output area, @ the flyback, or in the PWM power supply. I can't
see it
on my scope. It's an ATC113CA1. Anyone see this? Dani.

.

Relevant Pages

  • 36" RCA T.V.
    ... but has minor noise in pix. ... I can't see it on my scope. ... Dani. ...
    (sci.electronics.repair)
  • Re: Samsung Projection T.V.
    ... Dani wrote: ... five hours, then shuts down, & flashes the power led nine times, then ... Pix is fine. ... Real Programmers Do things like this. ...
    (sci.electronics.repair)
  • Re: Dead Ctc203
    ... Dani Wrote: ... > The loose thermistor MAY have caused the fuse to ... > blow, but the bad connection at the horizontal drive coil, this causes ... > pix of the top & bottom of the board, ...
    (sci.electronics.repair)
  • Sony projection.
    ... wavey blue, & red lines, after half an hour, pix goes red. ... CRT problem? ... Thanks, Dani. ...
    (sci.electronics.repair)