Re: Repairing a 4-in-1 radio receiver

Den Sat, 10 Jun 2006 04:40:34 -0700. skrev drawyoursmile:

have. Here are the pictures.

http://img83.imageshack.us/img83/6867/lamacent48lw.jpg

Take a look at the resistor marked R82 it looks like it is dead. The value
0.82 ohms looks like a short at your meter.



--
Med venlig hilsen

Christian Treldal, OZ1GNN
"Remember Darwin; building a better mousetrap merely results in smarter mice."

.

Relevant Pages

  • Re: Bafflement
    ... It says 50 ohms on the label ... But my meter says it's a dead short ...
    (uk.radio.amateur)
  • Re: 6SN7 amp: what am I seeing?
    ... With the Fluke 8600A, one side of the OT shows 430vdc and the other side shows 455vdc. ... Across the outer legs, 660 ohms, one side to CT 286 ohms, the other side to CT 373 ohms, added together = 663 ohms, so I think, OK. ... I touched the chassis and nothing (meter, ... so maybe I can plug in and see if the amp actually works. ...
    (alt.guitar.amps)
  • Re: 6SN7 amp: what am I seeing?
    ... The Tripplett shows the voltages at 445 and 455. ... the outer legs, 660 ohms, one side to CT 286 ohms, the other side to CT ... The Fluke sees it pretty consistently. ... If your meter has a leaky rectifier, ...
    (alt.guitar.amps)
  • Re: Chrysler quality
    ... Check fuses with a load testing device such as a test lite, not an ohm meter. ... measure the resistance in ohms using an ohm meter. ... When Glenn said "it is possible to ohm out a faulty fuse", ...
    (rec.autos.makers.chrysler)
  • Re: Measuring mA (debate solution needed)
    ... A typical 3.75 digit meter I have here exhibits a whooping 5.5 ohms!!! ... really DON'T want to have the measurement changing the circuit values. ... Even more than you might think given that LEDs are non-linear ...
    (sci.electronics.design)