Re: Industrial Sewing Machine motor brushes - Sandor Corp manf

In article <1151552900.544948.231150@xxxxxxxxxxxxxxxxxxxxxxxxxxx>,
Margecam52 <margecam52@xxxxxxxxxxxx> wrote:
Would you know if I find brushes the correct size, but with different
config on wire placement.. if it would matter as long as I can connect
them?

I'd go about it the other way round - find ones oversize with the correct
springs. They're only carbon, and easy to shape to size. Put some fine
abrasive *** - sandpaper even - on a glass *** or other flat surface
and rub the brush on it until the correct dimensions are obtained.

--
*Whatever kind of look you were going for, you missed.

Dave Plowman dave@xxxxxxxxxxxxxxx London SW
To e-mail, change noise into sound.
.

Quantcast