Re: Reasons for devices failing throughout the house



mungolurky@xxxxxxxxxxx writes:

Hi,

I have no experience of this sort of thing, so excuse the naivety of my
question... In the course of the last few days, our house has
experienced at least six electrical items failing. This includes a
network router and a set of speakers, both of which stopped working
sometime during Sunday night. Countless other devices have failed since
then, including a Sky+ satellite box, an electric fly catcher, a wall
heater... I know all this could just be bad luck and we're seeing a
pattern where there isn't one, but could there be anything that could
have caused these apparently unrelated faults? We use surge protectors
to protect our computers, yet the speakers and network router failed at
some point in the middle of the night.

Again, apologies if this sounds naive but I'd like to know if I'm just
being paranoid before I call an engineer in to chase these ghosts...
:-)

Just because you might be paranoid doesn't mean they aren't out to get you. :)

6 items in a week is probably not chance. There is something going on.

Has anyone determined how they failed? My guess would be high line voltage
or line voltage spikes.

Check the AC line voltage on the circuits where these devices were.

It's possible there is an open Neutral or a bad connection to the Neutral
resulting in excessive AC voltage on some circuits. Do you experience
unusual dimming, or more significantly, brightening of lights when
a load kicks in like a fridge or A/C compressor? The latter would be an
indication of a Neutral problem.

--- sam | Sci.Electronics.Repair FAQ: http://www.repairfaq.org/
Repair | Main Table of Contents: http://www.repairfaq.org/REPAIR/
+Lasers | Sam's Laser FAQ: http://www.repairfaq.org/sam/lasersam.htm
| Mirror Sites: http://www.repairfaq.org/REPAIR/F_mirror.html

Important: Anything sent to the email address in the message header above is
ignored unless my full name AND either lasers or electronics is included in the
subject line. Or, you can contact me via the Feedback Form in the FAQs.
.



Relevant Pages

  • Re: Don, Noons: TIF v. JPG. More samples.
    ... Recently, Colin D posted: ... the basic electronics should be well understood. ... It is *unnecessary* to know the voltage. ... The simple fact is that YOU brought up the power handling ...
    (comp.periphs.scanners)
  • Re: Confusion Over Batteries.......
    ... >I've been studying electronics in school and college for years). ... >When analysing circuits on paper everything is nice and obeys ohm's law ... But I recently discovered that batteries will only ... >terminal voltage will drop if asked to supply high currents, ...
    (sci.electronics.design)
  • Re: Worst hobby construction project of all time?
    ... > I seem to remember one Electronics Now ... >> used a 32 volt incandescent bulb lit to normal brightness, ... >> the voltage and one-third the current. ... >> a patent being granted on a mainstay circuit found in most any ...
    (sci.electronics.design)
  • Re: Strange Grounding Problem with LV System
    ... >> is for another 10 per channel of these lights. ... >> the trunking that contains the transformer and connection blocks. ... That's pretty normal on some low voltage lights. ... Take a look at my electronics web links and documents at ...
    (rec.arts.theatre.stagecraft)
  • Re: What DIY voltage regulator for DIY bike lights???
    ... I am tech and know electronics. ... 7.2 volts is 7.2v and the lamp doesn't care where it came from. ... Now here's the problem with linear regulators, they cause a voltage drop under ... when your battery discharges to 7.2 ...
    (rec.bicycles.tech)