Re: A/C plug gets too hot

Thank you! Yes, I HAVE unplugged it for now. I do not see any
corrosion on the plug, but there are tell tale signs on the plug
itself, like burn marks near the metallic part (the correct term
escapes me!), and the wire closer to the plug gets hot and soft as
well. Can replacing the plug be a SAFE solution, or will it still carry
some danger with it? How do I fix it if there is a near break in the
wires inside?

A properly replaced plug is safe. (Make sure you know which wire goes to
which prong; you can use an ohmmeter on the old plug and the cut-off wire to
verify this.) Simply cut off the wire far enough away from the original
plug to get past the break. Can you identify the exact spot that the heat
is coming from?


.

Relevant Pages

  • Re: Laptop trips GFI
    ... Thanks Terry, you know the first thing I was going to do when I realized it ... >> it was the Dell that had the three wire plug. ... >>>Maybe nothing else is plugged into this OUTLET GFI. ...
    (rec.boats.electronics)
  • Re: getting bit by my FT-101EE chassis
    ... > I believe the important thing here is that a three wire plug be used and> that it gets wired correctly. ... I will never see why the neutral which is> grounded and green wire which is ground cannot be tied together. ... is no harm in tieing the safety ground and neutral together. ... This is to protect a barefooted doofus from getting electrocuted when he is standing on the cement floor in the basement, and trys to operate his FT-101E. ...
    (rec.radio.amateur.boatanchors)
  • Re: Voice annunciated test box circuitry
    ... > triggered by a voltage when that wire is touched. ... The voice chips are fairly expensive, so I think getting a slew of them ... The plug pin you want to identify is then grounded. ...
    (sci.electronics.basics)
  • Re: Dryer connection (was Re: Air conditioner problem)
    ... There is a red wire, a black wire, ... wires are connected to the slanted terminals while ... because the neutral leg is grounded. ... By the way, Matt, the plug I am talking about is a 10-30, not a 6-30. ...
    (rec.outdoors.rv-travel)
  • Re: Using my genny for power outage at home
    ... I just went to Home Depot, and typed transfer switch into the search ... I would make a run of 2 lengths of 10/2 wire. ... RV, I would install a male, 30 amp, 4 connector dryer plug, and have some ... To the neutral blade connection, ...
    (rec.outdoors.rv-travel)