Re: Bowing of screen on Sony Trinitron Flatscreen 17" Monitor


<tmod700@xxxxxxxxx> wrote in message
news:1156983803.618621.77760@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxx


Hi Dave,

Thanks for the reply.

Oddly enough it doesn't really have the bow on the top of the screen.

It seems to all be on the bottom.

So would adjusting the yoke possibly take care of the bottom bowing
without affecting the top much?

Tmod


It's possible if the yoke has been badly fitted at the factory, ie, not
central and drooping slightly, to lift it a little and affect the bottom
with only minimal affect on the top. It depends on the individual case.
It's not a job I'd recommend if you're not electronically minded or
experienced with CRTs though- there's a real risk of seriously messing up
the picture and worse still getting a hefty shock.

Morse


.

Relevant Pages

  • Re: Bowing of screen on Sony Trinitron Flatscreen 17" Monitor
    ... Oddly enough it doesn't really have the bow on the top of the screen. ... It seems to all be on the bottom. ... So would adjusting the yoke possibly take care of the bottom bowing ... It's possible if the yoke has been badly fitted at the factory, ie, not ...
    (sci.electronics.repair)
  • Panasonic TV Model CT-27SL13G, Odd Symptom
    ... The picture is about 6 inches high (black on top and ... bottom), but it is "warped" with a wavy edge. ... excessive ripple, but found around 2V P-P ripple. ... yoke tester even though I didn't think it is the cause. ...
    (sci.electronics.repair)
  • Re: OT: Important Sartorial Question
    ... >the backs of shirts, usually at the bottom of the yoke, but sometimes ...
    (uk.rec.motorcycles)
  • Re: TECH: fun with Yokes
    ... So as a fun project and experiment, I decided to try and make an XY yoke:) ... connection board so it matched the amplifone yoke, ... the bottom and finished at the top. ... extra windings based on the difference in surface area. ...
    (rec.games.video.arcade.collecting)
  • Re: TECH: fun with Yokes
    ... So as a fun project and experiment, I decided to try and make an XY yoke:) ... connection board so it matched the amplifone yoke, ie. one side started winding at the top and finished at the bottom, the other side started at ... the bottom and finished at the top. ... extra windings based on the difference in surface area. ...
    (rec.games.video.arcade.collecting)