Re: Maytag dishwater control board... thermistor part number ?

Homer J Simpson wrote:

"Michael A. Terrell" <mike.terrell@xxxxxxxxxxxxx> wrote in message
news:450C76BE.9B3FEC1D@xxxxxxxxxxxxxxxx

A 1 meg resistor?

How many 1 meg thermistors have you seen?

It wasn't a thermistor.


You thought it was when you told him to replace it with a fixed
resistor.


--
Service to my country? Been there, Done that, and I've got my DD214 to
prove it.
Member of DAV #85.

Michael A. Terrell
Central Florida
.

Relevant Pages

  • Re: resistor in series and parallel
    ... I've a NTC thermistor and I'd like to change its response curve. ... I can linearise the thermistor using a series resistor. ... the range you want to linearize for, with a statement like: ...
    (sci.electronics.design)
  • Re: RMS approximation of Square/PWM signal
    ... NTC thermistor superglued to it. ... than the resistor on which it's mounted. ... It's a design to fit inside a customized D cell maglite. ... and stat fiddling with the RMS converter feedback to the Ti TL5001. ...
    (sci.electronics.design)
  • Re: RMS approximation of Square/PWM signal
    ... NTC thermistor superglued to it. ... would get because the thermistor would be getting heat from a source other ... than the resistor on which it's mounted. ... But the lamp is right next to it too. ...
    (sci.electronics.design)
  • Re: Maytag dishwater control board... thermistor part number ?
    ... to the ambient heat. ... As a test, use a resistor. ... to the thermistor to use. ... transfer station where I dump the used steel from computers, ...
    (sci.electronics.repair)
  • Re: determining characteristics of unknown peltier module?
    ... its size and the fact that it is drawing 6 amps at 12 volts. ... Put a power resistor and a thermistor on the cold side. ...
    (sci.electronics.design)