Re: Green Screen

junexsils wrote:
[]About 3 weeks ago while watching tv, the picture went green with
lines
running across the screens. I couldnt change the channel, there was no
volume and only thing I could do was switch it off. After about 20
minutes the picture came back on and it was fine.....

Until tonight. Again same thing happened but this time it hasent fixed
itself. From reading other posts it goes on about CRT drive. Can
anyone
clarify if this is the problem?[



color drive transistor in the crt
socket is bad.i have the same problem as you have few months ago.and
i fixed it by replacing the transistor.check the voltage under green.

Could be the socket, the drive transistor, a solder connection, or the crt
itself shorting internally heater to cathode.

Mark Z.


.

Relevant Pages

  • Re: more scope questions
    ... Trace back and find the spot where it dies. ... output amplifier driving the two horz plates... ... Find the number on the CRT tube, ... Wiggle the socket on the back of the CRT first... ...
    (alt.guitar.amps)
  • Re: more scope questions
    ... Trace back and find the spot where it dies. ... output amplifier driving the two horz plates... ... Find the number on the CRT tube, ... Wiggle the socket on the back of the CRT first... ...
    (alt.guitar.amps)
  • Re: Identifying shorts in CRT socket spark gaps and repairing them
    ... I narrowed the problem down as being inside the CRT, ... also very well be in the CRT socket, the spark gaps to be precise. ... the spark gapfor the problem pins. ...
    (sci.electronics.repair)
  • Re: Identifying shorts in CRT socket spark gaps and repairing them
    ... thought I narrowed the problem down as being inside the CRT, ... problem could also very well be in the CRT socket, the spark gaps to ... Remove the socket and test ... Are those the holes next to the pin ...
    (sci.electronics.repair)
  • Identifying shorts in CRT socket spark gaps and repairing them
    ... I've been having troubles with an Eizo T766 19" CRT; ... pins from the neck board, ... Remove the socket and test between the ... If the CRT itself is fine, the spark gaps ...
    (sci.electronics.repair)