Re: Bad computer monitor...

Homer J Simpson wrote:
"lj_robins" <lj_robins@xxxxxxxxxxx> wrote in message
news:g4udnTT7lLfYS7zYnZ2dnUVZ_oSdnZ2d@xxxxxxxxxxxxxx

When you first turn it in the relays click like they are supposed to,
after a moment or two the little "Check signal" window pops up, but it is
scrunched on the left side and spread way apart on the right side. The
screen looks normal otherwise.

Shorted turn in the yoke?












Hi, thanks for replying.

I pulled the 4-pin connector off the circuit board, the Blue and Red wires make one loop, they are reading 0.7 ohms, the Yellow and Brown wires make the second loop, they reading 7.6 ohms.

I'm assuming and the 0.7 ohms on the red and blue wires is not normal. All four wires feed into a closed module sitting on top of the neck of the CRT. I'm going to open this (if possible without destroying it) and see if the source of the burning smell was coming from inside it.

The bottom of it's circuit board is visible, there are schematic symbols of resistors, etc. silk screened onto it.

More later...


-Landon
.

Relevant Pages

  • Re: 10/100BaseT Impedance Mismatch
    ... the impedance is a function of the trace width, ... >> characteristic impedance. ... wires from the incoming Ethernet twisted pair wire to one of such ... This arrangement would give you 100 ohms differential ...
    (comp.dcom.lans.ethernet)
  • Re: DC Power Transmission
    ... wires two inches in diameter and spaced 200 inches apart, ... will be pretty nearly 636 ohms resistive. ... resistance of the conductors is an appreciable fraction of the ... quite close for differential mode of two wires of a three-wire line, ...
    (sci.electronics.design)
  • Re: DC Power Transmission
    ... wires two inches in diameter and spaced 200 inches apart, ... will be pretty nearly 636 ohms resistive. ... resistance of the conductors is an appreciable fraction of the ... be quite close for differential mode of two wires of a three-wire ...
    (sci.electronics.design)
  • Re: Mystery Motor/Generator with some clues
    ... kW, 110 VDC, 27 amp, shunt wound machine. ... wires which are connected to the brushes and the rotor, ... read about 2 ohms. ... A shunt-wound generator will not self-excite unless ...
    (sci.electronics.design)
  • Re: DC Motor/Generator help - where to go
    ... plate was a 4 way terminal block and two of the wires were out. ... have 358 ohms on one circuit and 2.3 ohms on the other - which is at least ... the higher resistance will be the field. ...
    (uk.rec.models.engineering)