Capacitor Start, Capacitor Run Motor



I havd an air compressor that has the Subject line type of motor,
115vac. It only has about 200 hours on it. I had left it on for a
couple of days recently and found that my circuit breaker in my garage
was tripped. I restet it and the compressor started(surprised me
because I didn't remember leaving it on.). It ran about 2 seconds and
the circuit breaker kicked, again.
Before I tore into the compressor, I made sure it wasn't the circuit
breaker by plugging into the utility room circuit, 23 seconds later, it
kicked that breaker.
The strange thing is that it sounds different than before. It did have
a deeper, stronger sound when the motor was running, now it sounds
kinda puny. When the motor starts and runs, it turns the compressor
pump an actually builds a small amount of pressure before it kicks off.
I have pulled the starting cap and the run cap to get the numbers off,
and have found them online. However, before I buy them, I was wondering
if this sounds more like the main winding (not the startup winding) may
be burned out. I haven't opened the case on the motor to look, yet, but
I wouldn't think that the winding would NORMALLY short (thus more
current), but sometime during the few days that I had left the
compressor on, we had a lightning hit that destoyed a dvd player and an
audio amp.
It could be coincidence.
Anyway, what would cause the motor to pull excess current. Would the
run cap being bad cause this?
I have checked both caps with a DMM, and all I can say is that they are
not shorted.

.



Relevant Pages

  • Re: Replacing compressor unit question?
    ... I'm willing to bet you'll be fine with the "5" hp compressor. ... Horsepower is 746 watts and a 5 hp motor ... They have a "3-HP" twin compressor pump on sale for $89. ... The pulley on the motor is about 2-1/2" and the existing pump ...
    (rec.aviation.homebuilt)
  • Re: Replacing compressor unit question?
    ... I'm willing to bet you'll be fine with the "5" hp compressor. ... If your old Sears motor is 36 years old it's probably REALLY 3 HP while the newer ones rate their "hp" at the instant locked rotor amps... ... They won't sell the ... display unit that's bolted to the counter. ...
    (rec.aviation.homebuilt)
  • Re: Quincy compressor/3-phase redux
    ... They are willing to supply me with 3-phase power, ... Even with the house main upgraded to 200A, ... plasma cutter or a big welder and the compressor kicks while the AC ... actually just a 15 HP single phase motor with long leads and a funny way ...
    (rec.crafts.metalworking)
  • Re: Update 1, Siemens SED2 VFD / Quincy 10 HP compressor troubles
    ... Changing V/f curve does seem to change things a little, ... compressor spins freely, such as when running with a gas motor that is ... is a 10 HP motor. ... The motor, when VFD turns on, only spins at maybe 60 to 90 RPM. ...
    (rec.crafts.metalworking)
  • Update 1, Siemens SED2 VFD / Quincy 10 HP compressor troubles
    ... Changing V/f curve does seem to change things a little, ... compressor spins freely, such as when running with a gas motor that is ... is a 10 HP motor. ... The motor, when VFD turns on, only spins at maybe 60 to 90 RPM. ...
    (rec.crafts.metalworking)