13" Sanyo tv model:31C460U,chassis:G2C-460uo,year:June 89

Relevant Pages

• Re: 13" Sanyo tv model:31C460U,chassis:G2C-460uo,year:June 89
  ... The relay coil is missing it's B+ as the SPMS power supply is dead,I ... replaced the opto couplers but no luck.Anyone have any tips?.Thanks. ... bad voltage regulator? ...
  (sci.electronics.repair)
• Re: Using a Maxtor Drive to Upgrade Sky+
  ... the owner of a Sky+ receiver ... It seems to me that you're all missing the point that the HDD is powered ...
  (uk.tech.tv.sky)
• Re: How do you extract the info from an RF Rx module (like garage door opener) ?
  ... I've been experimenting with receiver circuits and I'm missing something. ... The LC receiver I have and the Microchip seem to have noise at the output when they're not receiving a signal. ... Many of the low-cost RX modules have no filter on their outputs, so you get noise when there's no signal. ...
  (comp.arch.embedded)
• How do you extract the info from an RF Rx module (like garage door opener) ?
  ... I've been experimenting with receiver circuits and I'm missing something. ... So that a high or low transition could be used ... to trigger an IRQ and decode the signal? ...
  (comp.arch.embedded)
• Re: See how simple a Bellcore message is
  ... > the algorith for the checksum is missing. ... Fortunately this is a simple verification that the message has been received ... However it is very important to get this right if a manual raw Caller ID ... message had to be written and a manual receiver verification had to be ...
  (microsoft.public.win32.programmer.tapi)