Tech Help Hitachi, 65SWX20B



My tv shut off last night. I finally got it to power up and stay up
with the sound just no pic. I figured out that when I unplug the 5 pin
connector that leads from the red light tube from the power board the
board will come on and stay up. If I try to plug it back in it will
give off a snap, small spark and shut the tv off.. The connector has 5
wires, one pink and four brown. With my meter I can put the pos on the
pink and go alone three of the browns and get 250V. On one of the
browns there is no power. Any ideas or tests I can do.. Any help will
be appreciated.

.



Relevant Pages

  • Gottlieb System 1 power supply/transformer question
    ... I've been diligently following the System 1 repair guide at ... reinstalled the power pcb. ... I just now got to the point of attaching the power board to the bottom ... between the transformer and the power board input that could have ...
    (rec.games.pinball)
  • Re: Tech: Flipper Power Board Electrical Theory
    ... then getting a whole powerboard getting a second flipper power board ... including millioniare) have other solenoids connected to the ... flipper power board. ...
    (rec.games.pinball)
  • Re: Gottlieb System 1 power supply/transformer question
    ... make certain that you run a ground off of the power supply. ... Before writing off your transformer, double check your 69vac readings at the transformer again. ... I just now got to the point of attaching the power board to the bottom ...
    (rec.games.pinball)
  • Re: Flash Gordon help
    ... I power it up and it seems to go into ... out of the three flippers I'm only getting power to one flipper unit. ... Lastly I checked the transistors on the solenoid board. ... solenoid board at connector J3 back to the power board and it did buzz ...
    (rec.games.pinball)
  • Re: Stern Flight 2000 boot problem
    ... connector. ... Just unplug and plug the ones to the power board back in and ... the power supply board, new filter cap & 5v regulator on the SDU, (and ... If I let it sit for a day or so, it will usually boot up again. ...
    (rec.games.pinball)

Quantcast