Re: How do I open a Dell AC Adapter?


this fault sounds like bad electrolytic caps, especially if there is
hissing and heat. this may have been brought on by a short in the
cable. either way, given that you may well break the thing by getting
it open I'd start looking for another.
-B.

.

Relevant Pages

  • Re: Ibm p202 problems
    ... fault is most likely in the pin amp and horiz scan areas. ... I have an IBM p202 that has problems at some scan rates it has a pin ... a section of the D board that was heat sensitive. ... dryer it starts messing up almost as fast. ...
    (sci.electronics.repair)
  • Re: Sony KV-27S36 HV-to-flyback connector
    ... I have my doubts has anything to do with the flyback, ... Most of the common failures in your model series for this type of fault are ... Use a heat gun and circuit freeze to troubleshoot for the fault. ...
    (sci.electronics.repair)
  • Re: Kings Cross re-opening?
    ... could be wrapped them with circulating water pipes and used to heat the ... borough of Camden... ... fault, but are still using standard policy to say it will take longer ...
    (uk.railway)
  • Re: Tek 647 Scope CRT Circuit
    ... I would try using a heat gun and freeze spray to provoke the fault. ... Start with the electrolytic caps in the power supply and HV generator. ...
    (sci.electronics.repair)
  • Re: OT: with 1.5 work days left in there year, here it comes i can feel it....
    ... Personally, I put that one on the same list as, "Yeah, but it's a dry ... > What fucking idiot is going to be the first person to say  ... fault, my fault, nobody's fault...no matter what else happens, I'm gonna' ...
    (rec.gambling.poker)