Re: Projection Lamp for projection TV

Andy wrote:
Andy asks:

I see these TV projection sets for under $1000 and it seems like
a good deal until I read that the lamp has a 90 day warranty or some
other short time.... And, from what I can find, the replacement lamps
are like $500 each.....

Does anyone here with experience in these items care to take
a minute to talk about the best, most reliable, projectors... or any
comments on lower cost projection lamps ?

Thanks in advance,

Andy in Eureka, Texas

Andy,

Many front projectors need lamps in about 2000 hours, and it is a bad idea to try to reset the timer until the lamp just blows, as it can cause serious damage to the projector. In some cases, it might kill power supplies when it goes, or it might shatter, causing shards of glass to go everywhere. Some lamps contain mercury and you certainly don't want one of those shattering. Heck, it probably costs 10 cents an hour for electricity to run the projector, you just don't get it as a single item bill.

You have to look at the lamp as an operating expense of the projector. So, if the bulb is $400 and lasts 2000 hours, that's 20 cents per hour for a lamp. It's sort of like buying $400 worth of tires for you car every 40,000 miles. It's a 1 cent per mile cost.

My father uses his projector several hours per day, and I just replace the lamp in his 20 month old projector, which was worth doing. I use my projector much less, around 5-8 hours per week. So I expect that when I need a lamp, my projector will be 8 or 10 years old, and I'll want to replace the entire projector, as the technology will have made advances (or so I hope) by then.

Hope this helps you make a decision. Also, I agree with the other replies, use a factory approved lamp.

Regards,
Tim Schwartz
Bristol Electronics
.

Relevant Pages

  • Re: Lighter image
    ... Get a new bulb ready! ... see Ellie's post about lamp costs. ... Then find out what model projector you have and make enquiries about ... spare lamps. ...
    (uk.education.staffroom)
  • Re: Projection Lamp for projection TV
    ... Tim Schwartz wrote: ... Many front projectors need lamps in about 2000 hours, and it is a bad idea to try to reset the timer until the lamp just blows, as it can cause serious damage to the projector. ... You're father may find that after a bulb change or two, that other parts of the unit begin to deteriorate, depending on the model and make. ...
    (sci.electronics.repair)
  • Re: Slide projector melting my 35mm slides -- any advice?
    ... <<My aunt says that when the slide projector bulb gets ... That seems unlikely unless the lamp somehow fails ... In an ordinary projector, the condenser lens directs ...
    (alt.photography)
  • Re: Robber Baron craps out...
    ... probably know a little bit more about paying staff than you do. ... I advised against the projector, ... projector and deduced that the lamp had gone belly-up. ... Anyone with half a brain adds the cost of the item and shipping costs to ...
    (uk.rec.audio)
  • Re: Robber Baron craps out...
    ... probably know a little bit more about paying staff than you do. ... decided to buy a used projector. ... retrieved the projector and deduced that the lamp had gone ... Anyone with half a brain adds the cost of the item and shipping costs ...
    (uk.rec.audio)