Re: Audiophile cappacitor replacement comments
- From: szekeres@xxxxxxxx (GregS)
- Date: Tue, 06 Feb 2007 19:41:23 GMT
In article <T_2yh.300$y3.39@llnews>, tomh <nospam@xxxxxxxxxx> wrote:
ahhh, just to put my oar in.
While I don't believe all the high end audio snake oil claims about
this or that brand of capacitor. Going through a good quality amp and
replacing the coupling/filter caps with polypropylene polystyrene types
can make a subtle but audible difference even to the non "golden eared"
set.
Yes it's a lot of work and finding all the right values can be
difficult and expensive. And the plastic film types tend to be 2-3 times
larger, which can be a problem.
Is it worth it? good question. If it ain't broke... If your amp is 20+
years old just doing a general replacement with new capacitors, fancy
one's or not, will probably make a world of difference. Also if the rest
of your system is not "up to snuff", the difference might not be
noticeable.
As a first experiment try replacing the capacitors in your speaker
crossover. There size is usually not a problem and you can gang 'em up
if needed to get the right value. If that makes a discernible difference
to you then consider pressing on.
If you know how to work speakers, then you might be able to change
caps. I assume your talking about replacing electrolytics with p-p
types. The ESR will change and you cannot use the same values
of capacitance. Of course, the tolerance of the lytics is pretty bad.
Replacing electrolytics in amplifier coupling stages is a good idea
just for stability, and frequency and phase response can make drastic
changes with old lytics.
Amps don't have to be 20 years old to have problems.
greg
.
- References:
- Audiophile cappacitor replacement comments
- From: tomh
- Audiophile cappacitor replacement comments
- Prev by Date: Re: Power Amp Repair
- Next by Date: Re: Can cold weather damage electronics components and circuit boards?
- Previous by thread: Audiophile cappacitor replacement comments
- Index(es):
Relevant Pages
|
