Early 1970's Radar Range

From: Totalrod2@xxxxxxx
Date: 9 Feb 2007 14:20:15 -0800

I own an early 1970's Amana Radarange (with the analog dials and all
chrome front). It still works great but the window is all clouded and
dirty inside. I have a replacement I'd like to use. Here's my
problem... I can't remove those "safety" screws they used on the
door!
And I can't seem to find any tools that will work either. These are
not regular "safety screws" but look like something specially
designed
BY Amana. I plan on replacing them with normal screws if I can just
get the old ones out. Does anybody know where I can find the proper
tool for removing those screws?
Bryan

.

Follow-Ups:
- Re: Early 1970's Radar Range
  - From: N Cook
- Re: Early 1970's Radar Range
  - From: meow2222
- Re: Early 1970's Radar Range
  - From: Captain Midnight
- Re: Early 1970's Radar Range
  - From: Andy Cuffe
- Re: Early 1970's Radar Range
  - From: Totalrod2

Prev by Date: Re: PCB of garage door opener failed: Which PIC is this?
Next by Date: Re: Early 1970's Radar Range
Previous by thread: Yet another ICC5 chassis solution
Next by thread: Re: Early 1970's Radar Range
Index(es):
- Date
- Thread

Relevant Pages

Re: Early 1970s Radar Range
... dirty inside. ... I have a replacement I'd like to use. ... I can't remove those "safety" screws they used on the ... not regular "safety screws" but look like something specially ...
(sci.electronics.repair)
Re: Early 1970s Radar Range
... dirty inside. ... I have a replacement I'd like to use. ... I can't remove those "safety" screws they used on the ... not regular "safety screws" but look like something specially ...
(sci.electronics.repair)
Early 1970s Radar Range
... I own an early 1970's Amana Radar-Range (with the analog dials and all ... I have a replacement I'd like to use. ... I can't remove those "safety" screws they used on the door! ... not regular "safety screws" but look like something specially designed ...
(sci.electronics.equipment)
Re: Smoke from the (portable) XT
... There's an L-shaped piece of metal with 3 screws on the outer side plus 8 bolts holding the units in place that must be removed. ... a direct replacement of a faulty supply with a 5160 one may be impossible. ... The video card feeds the signal to the CRT through its onboard connector P1, but it's able to drive an external monitor too. ...
(comp.sys.ibm.pc.classic)
Re: MDF repair
... pull the rubber plugs out of the bottom of the hopper, remove the screws, ... and pull the hopper off. ... invert and remove two screws on bottom of doser chamber. ... Where is the best place to get replacement parts? ...
(alt.coffee)