Re: Starlite Consumer Products DVD Player question


"boardjunkie" <boardjunkie@xxxxxxxxxx> wrote in message
news:1171641247.071826.169420@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
On Feb 14, 11:53 pm, "hr(bob) hofm...@xxxxxxx" <hrhofm...@xxxxxxx>
wrote:
I have a 95 day old (90 day warranty) DVD player that intermittently
refuses to read dvds. Typically, after 4 or 5 loading tries, the disc
is finally recognized. When it fails, the LED lights up, the carriage
moves back and forth many times, the tv shows loading, and then
finally gives a no-disc signal on the tv. After I removed the cover,
nothing changed. I have pushed on all the cables and sockets, and
also pushed on the various PWBs, all with no changes noted.

Any suggestions besides adding to the next grbage collection.

H. R.(Bob) Hofmann

You may want to check out the spindle motor. Common failure with
requent use.

A friend of mine suckered me into making an attempt to revive a
Panasonic DVD-RV26 player recently. Did some research on the error
code (HO2) which was regarded to refer to pickup failure. Watching it
during spin up something didn't look quite right and there seemed to
be a little too much resistance when turning the disc platter
manually. I don't work on much consumer stuff so I don't have a stock
of motors to swap out to verify the problem. So I removed the motor
and popped the back off. Cleaned the shaft, bushings and brushes.
Lubed the bushings, assembled it and tossed it back in.
Took right off.

So I tell him I basically put a band-aid on the problem and if it
starts acting up again the motor needs replacing.


Error message " H02 " refers specifically to spindle motor failure on all
models of Panasonic. It does not indicate pickup failure, so wherever you
found that little gem on the 'net, it's wrong. The spindle motor for Pans
comes pre-assembled onto a subdeck, with the turntable already fitted, as
the turntable height is critical to correct operation.

Arfa


.

Relevant Pages

  • Re: Starlite Consumer Products DVD Player question
    ... Typically, after 4 or 5 loading tries, the disc ... You may want to check out the spindle motor. ... Lubed the bushings, assembled it and tossed it back in. ...
    (sci.electronics.repair)
  • Re: NAD S500 CD Player
    ... problem was that the drive motor sometimes doesn't spin up. ... forth a small amount to check that the laser is "home". ... disc in there, or the pickup is faulty, or the laser is not burning, or weak ...
    (sci.electronics.repair)
  • Re: CD player problem
    ... on the shaft of the sled motor. ... slides, you can feel it go bump-bump-bump as the gears rotate. ... the end of a disc, ... As the laser tracks towards the edge of the disc, ...
    (sci.electronics.repair)
  • Re: Non spinning CD spinner
    ... Taking the I/P Hof the releavant 1/4 of the BA6398 quad motor ... Taking the I/P Lof the isolated inv buffer on the BA6398 also ... If the focus coil hunts but doesn't ... Does disc rotate - N ...
    (sci.electronics.repair)
  • Re: Problem with portable band saw from HF
    ... I can't turn lower wheel by hand. ... I removed cover and found that when saw blade is on and upper disc in "tighten" position lower discis not rotating while motor is still running. ... point the motor gear no longer engages with the drive gear. ...
    (rec.crafts.metalworking)