Re: Need to fix old valve radio

On 4 Mar, 23:28, lafayettera...@xxxxxxxxxxxxxx wrote:
...and lastly, the radio has not been used since the last time I
tested
it about 10 years ago. Then it worked fine, no I tested it again and
suddenly there is this problem. It is entirely possible that it was
knocked (I hope not dropped) while in storage, but there is nothing
visibly broken, and all the valves do glow.
BTW, I tried removing the valves one by one and seeing if one valve
did not "make a difference", but this approach did not work, any valve
removed results in no sound at all.

Schematic now available, at
http://www.geocities.com/lafayetteradio1@xxxxxxxxxxxxxx

.

Relevant Pages

  • Re: OT: Home Improvement YAAAAHHHHHHHGGG!!!
    ... BTW ... ... charge is nothing in comparison to your aggitation and agrevation over ... Directions could cost you almost as much as a plumber... ... and most valves are made with a nut right there that holds the stem ...
    (alt.smokers.pipes)
  • Re: CRF450 Valves
    ... >I put an hour meter on my bike ('03 BTW) when I got it. ... I rode it for ... >two seasons before my valves tightened up significantly to the point ... top end job with replacing to intake valves after only 80 hours? ...
    (rec.motorcycles.dirt)
  • Re: Need to fix old valve radio
    ... the radio has not been used since the last time I ... I tried removing the valves one by one and seeing if one valve ... removed results in no sound at all. ...
    (sci.electronics.repair)
  • Re: Pic of my new bike
    ... Goldwing or gay thing. ... BTW, good one for doing the valves yourself, without Krusties help! ...
    (rec.motorcycles)
  • Re: Need to fix old valve radio
    ... BTW, I tried removing the valves one by one and seeing if one valve ... removed results in no sound at all. ...
    (sci.electronics.repair)