Re: How to measure High tension of a FBT. . .

spam <""rrrrfffftttt(no)\"@(spam)hotmail.com"> wrote in
news:130ojm5n6sojs5b@xxxxxxxxxxxxxxxxxx:



Let's see... a piece of plastic pipe about two feet long... a hundred
1 meg resistors soldered in series... 100 megohms... one end connected
to ground, the other to 27 kV... that's a current draw of only 270
microamps...

Too much load. The Fluke HV probe is 1000 Megohms,rated to 50KV,IIRC.


--
Jim Yanik
jyanik
at
kua.net
.

Relevant Pages

  • Re: using an HP 8405A to measure SWR ?
    ... >>>the source match to be set right there and the A probe to sample right ... >directional coupler provides the isolation between probes. ... you do want to measure the effects of the load on ...
    (rec.radio.amateur.antenna)
  • Re: Differential probes
    ... 1MHz square wave and it gives nice clean edges with little ringing. ... The Fluke is kind ... the FP120 is about 4x more noisy than the Tek. ... there is also a crowd who make the best damn diff probe there is. ...
    (sci.electronics.design)
  • Re: Differential probes
    ... a Fluke DP120 20MHz 1:20/1:200 probe loaned to me by an Agilent sales rep. gives miserably ringing edges. ... The Fluke is kind of silly in having 4 ft. long heavy cables with huge probes that look suitable for heavy duty power distribution probing. ... The Fluke must have a power supply in there to generate a negative supply, whereas the Tek just pulls clean power from the scope. ...
    (sci.electronics.design)
  • Re: HV probes, & flyback measuring.
    ... 2000uF, Inductance to 200 H, Resistance to 20M Ohm ... I use a Fluke HV probe that plugs into my multimeter. ... for using conservative ratings with lots of safety margin. ...
    (sci.electronics.repair)
  • Tech: How To Make High-Voltage Measurements?
    ... so I have my new Fluke 40 kV probe and Fluke 179 meter ready to make a ... high voltage measurement and adjustment if necessary on my Electrohome ... Do I poke the probe under ...
    (rec.games.video.arcade.collecting)