Re: Philips 29PT5408/01 Chassis: L04E - Fault code

The fault could be in the power supply, scan amplifiers, or in the
high voltage section. Most of the time, it is faulty components that
are going more out of specs as they heat up. This type of fault is not
able to be found without proper troubleshooting.

I would suggest taking the set to a service center to have it properly
checked. This is not the type of problem you will fix at home by
simply messing around inside the set. There are also some serious
safety issues when working inside of TV sets.


Jerry G.
======



On Jun 12, 4:54 pm, Patrick Craenen <t...@xxxxxxxxxxxxxxxx> wrote:
Brand: Philips
Type: 28PT5408/01
Chassis: L04E

Symptoms: Set does power up normally picture seems to be normal but
a little out of focus, after 10 to 20 minutes set goes to standby mode and
front led showing a fault code blink sequence:

1 long and 11 short flashes, led color is red for complete sequence.

Can anybody tell me what this fault code means as i don't have a service
manual.

Thanks in advance,
Patrick Craenen


.

Relevant Pages

  • Re: 1990 325i
    ... Fault Code directly on the Check engine lamp. ... codes by flashing the Check Engine light. ... once then it will start flashing the 4 digit codes. ...
    (alt.autos.bmw)
  • Re: Cleaning EGR Valve...
    ... The old EGR problem again, R.E. my old posting, I've had the new exhaust ... A fault code does not always show which part is faulty, ... the factors was telling me have been known to drop the centre electrode ...
    (uk.rec.cars.maintenance)
  • Re: Philips 29PT5408/01 Chassis: L04E - Fault code
    ... This type of fault is not ... front led showing a fault code blink sequence: ... Can anybody tell me what this fault code means as i don't have a service ...
    (sci.electronics.repair)
  • Re: 5.3-STABLE - system after few hours
    ... The error message on screen: ... page fault while in kernel mode ... >fault code = supervisor write, ...
    (freebsd-questions)
  • Proper way to shutdown a USB ethernet adapter?
    ... I get the same panic whenever I run "ifconfig axe0 down". ... page fault while in kernel mode ... fault code = supervisor read, ...
    (freebsd-questions)