.

I HAD SOME OLD HP TEST EQUIPMENT THAT DIDN'T WORK WHICH HAD A POWER
CORD THAT NOTHING MADE IN THE LAST 65 YEARS COULD USE SO I TIED IT
AROUND KENDRAS NECK AND PULLED ON IT AND YOU SHOULD HAVE SEEN KENDRA
TRY TO SCRATCH HER ARSE WITH A POWER CORD AROUND HER NECK.


.

Relevant Pages

  • Re: Fender amps - bad sounds when the voltage drops (question for the technicians)
    ... and the power was coming through 100ft extension ... fender Concert amp for the second set. ... voltage, or is there another explanation to consider? ... One thing you can do to help is get the "fattest" cord possible. ...
    (alt.guitar.amps)
  • Re: Kill a Watt(tm) power meters
    ... I left it plugged into a power ... I already had a decent digital multimeter that measures AC amps, ... :> input jacks and attached them to a length of AC two conductor cord, ... :> current draw and simple arithmetic gives me the watts. ...
    (alt.home.repair)
  • Re: RTD youre an idiot. (Smith & Jones plot hole a MILE wide!!)
    ... It just took the doctor ... You are suggesting the power in this machine would have ... Perhaps the cord was the control circuit, ... he WOULDN"T HAVE FISHED FOR HIS SONIC SCREWDRIVER: ...
    (rec.arts.drwho)
  • Re: EM TECH: Aztec not starting
    ... make sure your power switch didn't fail. ... I would suggest leaving the power cord alone, as long as it doesn't have any cuts or electrical tape wraps around it. ... It sounds like your set up at the transformer is typical WMS. ... They're the only manufacturer I know of that used wire nuts on the line cord from the factory. ...
    (rec.games.pinball)
  • Re: Building my hangar
    ... in place power tools, and instruments. ... areas so that you are not dragging a cord across it all the time. ... Same with the under the bench ... have a way to keep your soldering iron chord, ...
    (rec.models.rc.air)