Re: Phillips TV does not hold default channel
- From: b <reverend_rogers@xxxxxxxxx>
- Date: Sun, 17 Jun 2007 16:06:16 -0700
ms ha escrito:
I got a used 1992 Phillips 21" set. Set it manually to channel 73 for Dish
Network, to replace a smaller set at the same RF connection. It worked
normally with Dish Network, where the remote changes channels. Turned it
off, still plugged in and connected to Dish Network.
Next day, turned it on, it did not retain the previous channel 73 setting,
had defaulted back to channel 2.
The smaller older set was a 1985 Toshiba, but it retains the last channel
setting used, like any other TV I've used.
Is there a problem with the Phillips, or is this common in newer sets?
if you turn it off into standby with the remote, it should probably
switch on with the last channel watched. If however the hard on-off
switch on the set was used then it will revert to the forst channel
tuned in. in your case 2.
-b
.
- Follow-Ups:
- References:
- Prev by Date: Re: Bit off topic ...
- Next by Date: Re: Techs: What's on your Shelf of Weird Things?
- Previous by thread: Phillips TV does not hold default channel
- Next by thread: Re: Phillips TV does not hold default channel
- Index(es):
Relevant Pages
|
Loading