Re: Phillips TV does not hold default channel




"ms" <ms@xxxxxxxxxxx> wrote in message
news:5dnhhbF34le40U2@xxxxxxxxxxxxxxxxxxxxx
"JANA" <jana@xxxxxxxxxxxxxxxxxx> wrote in
news:137c2skolk90c4a@xxxxxxxxxxxxxxxxxx:

Make sure that the TV's AC cord is plugged directly to the main
outlet, and not through the decoder box (dish box).

Many models of TV sets, when switched off, if they loose the AC
supply, the default user memory will be re-set to the default.

If the TV set is being used properly, it is possible that there is a
defect with the internal memory of the TV set in the area that works
with the user set-up. In this case, the set will have to be serviced.
Some sets use an internal battery, while some other's use an internal
memory built in to one of the microcontroler chips. If the fault is
not directly from a memory battery, then servicing the set can get
fairly involved.


We will shortly go off Dish Network, just use a roof antenna, then with
only 5 local channels, changing the channel manually will be no problem.
And with so little to watch, I usually only watch the PBS channel anyway.

ms

?????????????????????

Arfa


.



Relevant Pages

  • Re: Phillips TV does not hold default channel
    ... and not through the decoder box (dish box). ... the default user memory will be re-set to the default. ... And with so little to watch, I usually only watch the PBS channel anyway. ...
    (sci.electronics.repair)
  • Re: Concerned about state of sky upgarde - comments please
    ... back tommorrow to arnage a time. ... connections ect,but if a new dish is required it would be a chargable ... replace the dish and make good the rest of the install. ... but memory might well be at fault. ...
    (uk.tech.digital-tv)
  • Re: A8N5X Beep code follow up
    ... Memory has been reseated in RAM slots, all connections are good--video card properly seated in its slot, and is secure. ... Any thoughts/comments/suggestions before purchasing replacement video card? ... Manual is incorrect when it states to use channel B1 and A1 when using 2 memory modules. ... is you were running a 2x512MB configuration in dual channel. ...
    (alt.comp.periphs.mainboard.asus)
  • Re: 4-way Opteron vs. Xeon-IBM X3 architecture
    ... DRAM devices, 18 devices per rank, 72 devices per channel running ... then you can raise the memory capacity of the 4P Opteron box to 64 GB. ... Your argument that the server folks can run with more memory ... in the memory system by pushing the configuration beyond the validated spec - does not hold water. ...
    (comp.sys.ibm.pc.hardware.chips)
  • Re: RAM question
    ... I was going to buy this stick of VS512MB400 today but at the last minute I decided to ring the store (CCL Computers). ... Is it possible to run the current 512MB stick in one channel and have a 1GB stick in the other channel or do capacitys have to match exactly. ... So <Insert four letter word here> would be an accurate ... together, it'll still work, it'll still give 1GB total memory. ...
    (microsoft.public.windowsxp.hardware)