Re: solder gauge?


"Smitty Two" <prestwhich@xxxxxxxxxxxxx> wrote in message
news:prestwhich-72BEFB.10065130062007@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
I work in manufacturing, not repair, and keep the human robots supplied
with .015, .020, .025, .031, .040, and .050 diameter solder. The range
of things we work on makes having a broad selection helpful. But I
wonder what repair techs use most frequently? (If I could only have one
size, I'd go with the .025 I think.) Also I assume you guys on the other
side of the ditch are using metric sizes?

I use almost exclusively 0.7mm for general repair work. I also have a reel
of 0.5mm for surface mount work, and some 1mm for 'heavy' work

Arfa


.

Relevant Pages

  • Re: solder gauge?
    ... Smitty Two wrote: ... of things we work on makes having a broad selection helpful. ... wonder what repair techs use most frequently? ... To e-mail, change noise into sound. ...
    (sci.electronics.repair)
  • Re: solder gauge?
    ... of things we work on makes having a broad selection helpful. ... wonder what repair techs use most frequently? ... Somewhere I have a roll of heavier stuff for big connections but ...
    (sci.electronics.repair)
  • Re: solder gauge?
    ... of things we work on makes having a broad selection helpful. ... wonder what repair techs use most frequently? ... of 0.5mm for surface mount work, and some 1mm for 'heavy' work ... Arfa ...
    (sci.electronics.repair)
  • Re: solder gauge?
    ... of things we work on makes having a broad selection helpful. ... wonder what repair techs use most frequently? ... I buy the lower temperature stuff. ...
    (sci.electronics.repair)