Re: "Reverse engineering" burnt resistors

I don't think you can come up with any useful table.

If you don't know the voltage across the resistor, or the current,
you're a bit short on the information front.

For most circuits you need to be no more than 20% off. With very
little information, you're guesses as to the voltage and current are
likely to each be off by much much more than that. Multiply one wild
guess by another and the results are not good.


.

Relevant Pages

  • Re: P2B-DS and generic slotkets
    ... The slockets are labeled "Cpu Card ... processors are requesting 2.0 volts instead of 1.65 volts. ... If R3 is a 56 ohm resistor, ... With regard to the voltage being requested, ...
    (alt.comp.periphs.mainboard.asus)
  • Re: Q: Reducing 20VDC Line to 12VDC
    ... on the line to solve the voltage difference. ... The flasher circuits on GTB's ... The only thing I'm concerned about is that a flasher lamp is an entirely ... I think that a 5 ohm 5W or 10W resistor will do the trick. ...
    (rec.games.pinball)
  • Re: Einsteins Doppler equation wrong?
    ... the voltage is zero, i.e dE/dt is at its greatest, and ceases when the ... short circuit. ... :>: consisted of a connector with a small resistor tying the core ... :>: Without the terminator, the thinnet cable spits back echoes into ...
    (sci.physics.relativity)
  • Re: P2B-DS and generic slotkets
    ... processors are requesting 2.0 volts instead of 1.65 volts. ... If R3 is a 56 ohm resistor, ... With regard to the voltage being requested, ... you sure the slocket doesn't have a way to modify the VID ...
    (alt.comp.periphs.mainboard.asus)
  • Re: Simple Linear Supply (for teaching my son)
    ... I intend to start by using a 3.3k ohm resistor for the "BASE DRIVE" ... might blow just charging the storage capacitor the first time. ... two or three blocks for the voltage ... The other BJTs won't heat much on ...
    (sci.electronics.basics)